Difference between revisions of "Installing VMware Server 2.0 on Windows Systems"

Revision as of 14:10, 25 September 2008

The objective of this chapter is to provide information on installing VMware Server 2.0 on the Microsoft Windows Server family of operating systems. For information on installing on Linux system refer to the chapter entitled Installing VMware Server 2.0 on Linux Systems.

Supported Windows Versions

VMware Server 2.0 is designed to run on Windows Server host operating systems and is not intended for use on desktop variants of Windows (such as Windows XP or Windows Vista). In addition, VMware Server 2.0 is not supported on Windows Server 2008. That said, the list of supported Windows operating systems is quite extensive and provides support for both 32-bit and 64-bit platforms.

The following table lists 32-bit Windows operating systems which are officially supported as VMware Server 2.0 hosts:

The 64-bit Windows server operating systems officially supported as VMware Server 2.0 hosts are as follows:

Downloading VMware Server 2.0 for Windows

VMware Server 2.0 for Windows may be downloaded free of charge from the VMware web site located at (www.vmware.com). The download process involves locating VMware Server 2.0 from the products page and submitting a moderately detailed form. Once the form has been submitted and the subsequent license agreement agreed to, the VMware Server 2.0 download page is presented.

VMware, Inc. provide the VMware Server software distribution in both 32-bit and 64-bit versions so it will be important to identify the CPU architecture of the host computer before downloading the software.

Also displayed on the download page will be serial numbers for both Linux and Windows installations. These will be required to unlock the VMware Server software during the installation process so be sure to make a careful note of them before dismissing the browser window.

Installing VMware Server 2.0 on Windows

The downloaded Windows installation file will have a name similar to VMware-server-2.x.x-xxxxxx.exe where the 'x' characters represent the current VMware Server 2.0 release and build numbers. To initiate the installation process, navigate to the location of the downloaded installer either using Windows Explorer or at the command prompt and execute the file. After a short delay while the installer unpacks the files necessary to proceed, the Installation Wizard for VMware Server welcome screen will appear. On this screen, click Next, read and accept the license agreement and click Next once again. On the Destination Folder screen either accept the default location into which VMware Server is to be installed (typically \Program Files\VMware\VMware Server\) or use the Change button to specify an alternate location. The next screen contains the server configuration settings as illustrated in the following figure:

As illustrated above, this screen is preconfigured with the fully qualified domain name (FQDN) of the local server and also the default ports for accessing the VMware Infrastructure Web interface using a web browser. Unless there is a need to change these settings (perhaps because the ports are used by another application or firewall settings mandate use of different ports) leave these settings at their default values. Also present on this screen is a setting to control whether virtual machines are started or stopped automatically when the Windows system starts up and shuts down.

Once the server settings are complete, click Next' to proceed to the Configure Shortcuts screen. Options are available to place shortcuts to VMware on the desktop, start menu and quick launch bar. On the next screen, click Install to initiate the installation process. This process may take some time depending on the speed and current work load of the server on which the installation is taking place. Once the installation is complete, the Registration Information page will appear. on this page, enter the user name, company information and the serial number provided when the VMware Software was initially downloaded. If the serial number is not entered at this point it will need to be configured through the VI Web Access interface before any virtual machines can be created.

With the installation completed, click Finish to dismiss the installation wizard.

Accessing the VMware Infrastructure Web Access Interface